Service areas · Staten Island
Commercial Vehicle Wraps in Staten Island
Staten Island is the one borough where almost none of our work happens in the bay. Getting a work van from Tottenville to 4700 Northern Blvd means the Verrazzano and the BQE, or a loop through New Jersey, and either way a crew loses most of a working day. So we treat the island differently: we come to you, or we schedule a drop-off planned around your route rather than ours.
Design and printing happen in Long Island City, on 3M, Avery Dennison and Oracal cast films with a UV laminate over every print. The installation happens wherever your trucks are parked at 6 a.m., whether that is a driveway in Eltingville or a fenced lot off the West Shore Expressway.
Most of what we wrap on Staten Island belongs to the trades: contractor pickups, plumbing and HVAC vans, landscaping trucks with trailers, and the box trucks that run the industrial parks along the West Shore. We are 3M and Avery certified, and we plan island jobs in batches so a fleet of six can be lettered in a single visit. The photos on this page are real Staten Island work: a pest-control van lettered with its Staten Island address.
What we wrap in Staten Island
The vehicles Staten Island businesses actually run
Contractor pickups and utility bodies
South Shore builders run crew-cab pickups with ladder racks and utility bodies. We letter the doors and tailgate and keep the rack area clear so lumber never scrapes the vinyl.
Plumbing and HVAC vans
Transit and ProMaster high-roofs are the standard service vehicle across the island. A partial wrap on the rear three-quarters puts the name, trade and phone number where a following driver actually reads it.
Landscaping trucks and trailers
Dump-bed trucks and enclosed trailers sit on residential streets all season while crews work. We letter both in matching colors so the trailer reads as the same company when it is dropped at a job.
Box trucks at West Shore industrial parks
Distributors along the West Shore Expressway run 16 to 26 foot box trucks that we wrap on site, one bay at a time, with the roll-up door handled so the print survives the rollers.
Shuttle vans and commuter buses
Operators running between the ferry terminal and the neighborhoods need lettering that stays legible through daily washing. We apply cast film correctly over the rivets and seams so it holds.
Food trucks near St. George
Trucks working the ferry crowds get a menu side printed in panels, so a section damaged by grease or heat can be swapped without redoing the whole truck.
Logistics
Working in Staten Island
On-site is the default
For Staten Island we assume the install happens at your location unless you tell us otherwise. We need a flat, reasonably clean parking spot, ideally under cover, and access to the vehicles for the day.
Scheduled drop-offs at the bay
If you would rather bring a single vehicle to Long Island City, we book a specific arrival window so it is washed, wrapped and ready before you make the return trip. Nobody should cross the Verrazzano twice for one van.
Batching a fleet into install days
With four or more vehicles, we group them into one or two consecutive on-site days. Morning trucks are done first, afternoon trucks come back to the yard by noon, and crews keep working while their vehicles are finished.
Proofing before we cross the bridge
Every design is approved by email before a sheet is printed. We measure on a first visit, or work from your VIN and photos, and send scaled proofs on the actual body outline. Nothing is loaded for the drive out until it is signed off.
Industries
Who we wrap for in Staten Island
- General contractors and home builders
- Plumbing and heating
- HVAC installation and service
- Landscaping and tree service
- Roofing and waterproofing
- Electrical contractors
- Distribution and warehousing
- Shuttle and commuter transport
- Food trucks and catering
- Moving companies
Neighborhoods
From the shop
Recent commercial work
Common questions from Staten Island
Do I really have to drive to Queens to get my trucks wrapped?+
No. For Staten Island fleets we bring the printed panels, tools and crew to your yard. We only suggest a trip to Long Island City for a single vehicle getting a full color-change wrap, where the controlled bay makes a real difference in the finish.
Can you make our lettering visible on the expressway at night?+
Yes. We stock reflective cast films for the name, phone number and USDOT lettering. Trucks that run the West Shore or Staten Island Expressway after dark get a version that lights up in headlights without changing how it looks by day.
How long is a van off the road for an on-site install?+
Lettering or a partial wrap is usually finished the same day it starts. A full box truck wrap can run into a second day, mainly because the box needs cleaning and the film needs time to settle before the truck goes back to work.
What happens if a panel gets damaged in a job-site scrape?+
We keep the print files for every vehicle we wrap. Because the graphics are printed in sections, we reprint the damaged panel and replace it on site without touching the rest of the truck.
Let's scope your project.
Send the vehicle list and artwork status; we'll come back with a scope and timeline, in the bay at 4700 Northern Blvd or on site in Staten Island.